[. . . ] Do not use outdoors or expose the appliance to the elements, humidity or heating sources (oven, fireplace, wet floor). Com² or accessories to excessive heat / cold (Keep between 0-30°C). Com² or use any accessory if it has been dropped, damaged, left outdoors or dropped in water. €  Never unplug or pull the mains power adaptor by the power cord. [. . . ] Com² may fail to reach the Charger Base Station if there are many obstacles in between it and the Charger Base Station. For best results ensure that the Charger Base Station is in a wide open space. By pressing the Automatic Return to Charger Base Station button on your Remote control** or the corresponding Sensitive Touch control on your Robo. Com² will not operate whilst charging or whilst connected directly to the mains power adaptor. COM² CLEANER Remote Control** Set Up To install batteries see Cleaner Maintenance - Replacing the batteries. Note: The Remote Control** can be used through walls because it works on radio waves not infrared. Virtual Barrier* Set Up To install batteries see Cleaner Maintenance - Replacing the batteries. com² cleaning certain rooms or areas such as in front of fireplaces. Before setting the Virtual Barrier* remember to: •  Remove any obstacles from the area that you want to block. €  The Virtual Barrier* should be placed on the same surface that the Robo. €  Ensure the Virtual Barrier* is more than 3m away from the Charger Base Station. CM MY S E CY Additional Features Automatic Return to the Charger Base Station: Press the Sensitive touch control on the robot or press the button on the remote control, this will activate the Automatic Return to the Charger Base Station NS CO I T I V E TO U N T ROL S C H CMY K UV Lamp*: Press the UV button on the remote control** to activate the UV lamp* for more hygienic cleaning. To deactivate the UV lamp*, just repress the UV button on the remote control**. Floor Polisher Pad*: Attached via the Floor Polisher Pad Holder * to the underside of the cleaner, the Floor Polisher Pad* is used to polish marble, parquet, wooden and other delicate NOTE: Do not use on a carpeted Surface. COM² CLEANER Before performing any maintenance task, ensure the Robo. Emptying the dust container Empty the dust container every cleaning cycle or when the dust container is full. Press the dust container release button and remove the Dust Container from the Robo. Use the Multi-purpose Cleaning Brush when necessary to remove any excess dust from the internal surface of the dust container. The filters should be cleaned every 5th dust container empty and should be washed. IMPORTANT: The filter should be cleaned and washed after the dust container has been emptied 5 times. Failure to clean your filter may result in air blockage, overheating and product failure. Press the dust container release button and remove the Dust Container from the Robo. [. . . ] Replacing the Virtual Barrier* batteries The Virtual Barrier* is fitted with 2 x D batteries. Remove the old batteries and replace with the new batteries ensuring the polarity is correct. 17 GB TROUBLESHOOTING The following is a list of commonly encountered problems and solutions. If any of these problems persist contact your local Hoover representative. [. . . ]